UNIFIBER PRIMER - Green Color - 0.75 LT - 4S4705-075 - AEMME

UNIFIBER PRIMER - Green Color - 0.75 LT - 4S4705-075 - AEMME

0 reviews / Write a review

Brand: AEMME
Product Code: 4S4705-075
Availability: In Stock

$32.43
Ex Tax: $32.43

Qty

UNIFIBER PRIMER - Green Color - 0.75 LT - 4S4705-075 - AEMME:

One-component primer for direct application on fiberglass hulls as a low thickness anchoring coat. Also used as a primer for antifouling or intermediate for joining two-component epoxy and/or polyurethane products and one-component finishes. Overpaintable with Topkapi enamel for finishing on superstructures and topsides or with suitable antifouling in the case of boat hulls

Available colors: Green Color

USAGE:

PREPARATION OF THE SUPPORT AND APPLICATION CYCLE

New fiberglass:

The surface must be perfectly clean, degreased with suitable detergents, rinsed lightly, sanded with fine sandpaper, and dusted.

Apply a coat of UNIFIBER PRIMER and let it dry for 6-8 hours.

Apply an intermediate coat of primer (NAUTICAL SUBSTRATE on topsides or SOLVER PRIMER on Opera Viva) and wait for the recommended drying. After 6-8 hours, sand and apply the desired one-component finish (one-component enamel or antifouling).

Fiberglass is already painted with two-component:

The pre-existing two-component paint must be well anchored to the substrate.

Then sand and apply a coat of UNIFIBER PRIMER and let it dry for 6-8 hours.

Apply an intermediate coat of primer (NAUTICAL SUBSTRATE on topsides or SOLVER PRIMER on Opera Viva) and wait for the recommended drying.

After 24 hours, sand and apply the desired one-component finish (one-component enamel or antifouling).

SAFETY PRECAUTIONS:

Before starting the application of the paint products, carefully observe the risk symbols and the safety rules shown on the label of each jar and on the Safety Data Sheet of each product available on request.

For further information do not hesitate to contact our Technical Department.

NOTE

The information contained herein is provided to the best of our current knowledge,

however as the conditions of use of our products are beyond our control, such information does not constitute any kind of implied warranty; in this sense, the supplier company declines from now on any responsibility that may be connected to an anomalous use of the products.

The Technical Department of its headquarters is available for any clarification related to the use of our products.

The percentages of dilution and drying times are to be considered only indicative, in relation to a temperature of 20 ° C, and are therefore subject to variations with the variation of the temperature, in the presence of particular climatic conditions or application factors determined at the time of 'application.

APPLICATION DATA
Application	Roller and spray brush
Application temperature	Between +10 c and +40 c
Brush-roller dilution	0-5% Thinner 765
Overcoating time	minimum 6 hours (20 ° c)
Recommended dry thickness	15 microns per hand
Relative humidity	Less than 80%
Spray dilution	10-20% Thinner 765
Theoretical yield m2 / liter	10
Touch dry	20-30 minutes (20 ° c)
FEATURES
Typology	Single component
Dry residue (volume)	24%
Specific weight kg / l (± 0.05)	1.180
Storage + 23 ° C (± 2)	30 months in sealed containers
Type of binder sol a	Modified vinyl
Viscosity ford	50 sec.

Write a review

Tags: Primer, Maintenance, Unifiber, High, Quality,