Prop shark Sol. A - 0.75LT - 5W70/BZ70-075 - AEMME

Prop shark - Part A 0.50LT - 5W7062-050 + Prop shark - part B - 0.75LT - 8Z7063-025::

Highly slippery biocide-free antifouling paint, with excellent expansion, scratch-resistant, hard and elastic. It is characterized by high slipperiness and anti-adhesion, which facilitates surface cleaning, used as a finishing coat in the nautical sector, reduces the attack of marine fouling especially both hard and soft fouling Recommended for propellers where speed is the turbulence generated by the rotation helps to keep the surface clean. Biocide-free product.

USAGE:

PREPARATION OF THE SUPPORT AND APPLICATION CYCLE

Supports: Aluminium, light alloys and other types of surfaces. The support must necessarily be pre-treated, abraded - roughened. Then apply 1 coat of PROPSHARK at the appropriate thickness. A second coat is possible within 1 hour of the first coat. after 2 hours apply after roughening, otherwise adhesion could be compromised.

PREPARATION OF THE SUPPORT AND APPLICATION CYCLE

Supports: Aluminium, light alloys and other types of surfaces. The support must necessarily be pre-treated, abraded - roughened. Then apply 1 coat of PROPSHARK at the appropriate thickness. A second coat is possible within 1 hour of the first coat. after 2 hours apply after roughening, otherwise adhesion could be compromised.

SAFETY PRECAUTIONS:

Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request. For further information please do not hesitate to contact our technical staff.

NOTES:

The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information. Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use. Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.