SureSeal Drip Free Self Aligning Shaft Seal in Metric Sizes - FSKM-XXM-METRIC - Tides Marine

SureSeal Drip Free Self Aligning Shaft Seal in Metric Sizes - FSKM-XXM-METRIC:

The SureSeal Shaft Seal is a drip-free, self-aligning propeller shaft seal that is OEM equipment on many well known brands and types of vessels. The SureSeal supports propeller shaft sizes ranging from 1 inch up to 8 inches and from 25 millimeters to 160 millimeters.

With Twin Engine vessels, we recommend the SureSeal model with dual injection fittings so a passive crossover line can be installed between the 2 SureSeal shaft seals. This way, if you are trolling or have a breakdown on one engine, cooling and lubricating water is still being supplied to the SureSeal that is on the idle engine.

If you install a Spare Seal Carrier Kit at the same time you install the SureSeal shaft seal, when the time comes, you will be able to change the Lip Seal in the water. No need to break the coupling or haul the vessel.

The only information needed to purchase a SureSeal shaft seal is your propeller shaft diameter, the OD of your stern tube and that you have verified that there is enough room between the end of the stern tube and the coupling to install the SureSeal.

The Minimum Distance required from the end of the stern tube to the coupling is 7 1/4 Inches.

Water from Raw Water Feed to SureSeal that delivers a minimum of 1 Gallon per Minute at Engine Idle Speed and increases as you throttle up, at a minimum of 2 psi.

Please note: If your propeller shaft is in poor condition with tool marks, rust or pits in the area where the seal will ride on the shaft, then the Tides SureSeal is not recommended. A "Face Seal" shaft seal would work better in this instance.

Key Features of the SureSeal include:

- ABS and Lloyds Type Approval.

- Minimal scheduled maintenance

- Replaceable Lip Seal while in the water (with Spare Seal Carrier Installed).

- Easy to Install.

HOUSING

Made from fiber-reinforced composite material, the housing is strong, durable and compact. The SureSeal® is dimensionally unaffected by temperature and will not absorb water.

BEARING

The integral PTFE bearing extends the operating life of the SureSeal® under normal operating conditions.

HOSE

Connecting the SureSeal® to the vessel is now easier with an “articulating hose”. This hose design automatically positions the SureSeal® the correct operating distance from the stern tube. No measurements are required – installation is simplified. The articulating hose reduces side loads to the SureSeal® when shaft misalignment occurs. As a result, lip seal and bearing life are extended.

LIP SEAL REPLACEMENT

The SureSeal® design incorporates a removable front cap which improves access to the lip seal. A worn lip seal can be replaced, even while the vessel is in the water, restoring the "100% watertight" characteristic of the SureSeal®.

INJECTION FITTING

The SureSeal water injection fitting is made from 316 stainless steel. Depending on the propeller shaft size, it comes in 3/8 or 1/2 inch sizes. A plastic cap is provided with each fitting so that if the injection hose has to be removed, the cap will restrict water flow into the vessel.