Costiera T.F. Antifouling - Hard Matrix - 2.50 Liter - Nero - Black - B65570-250 - AEMME

Costiera T.F. - Hard Matrix - 2.50 Liter Available in Black, Dark Blue or red - B65570-250 - AEMME:

Hard antifouling secure reliability with high percentage of cuprous oxide and ideal special substances for use in any type of sea.

It provides reliable protection on the hull, after application of a suitable primer.

It is applied to wooden hulls, iron and fiberglass (not suitable for aluminum hulls).

Ideal to speed even over 30 nodes.

Available colors: Black and Dark Blue.

USAGE:

PREPARING THE SURFACE AND APPLICATION CYCLE:

Hulls in new iron. Of iron sandblasted to grade 2.5 applies a coat of two-component EPOZINC 2C, letting it dry for 12-24 hours. (If it is not possible sandblasting is recommended to mechanically bring the iron again, clean the surface and apply one coat of CROMOMINIO-AT, leaving to dry for 8-12 hours.) Then apply two coats of PRIMER SOLVER 24 hours between of them. Overpainted with 2 coats of antifouling COASTAL T.F. at a distance at least 8 hours apart.  

Hulls in new wood. Apply a CROMOMINIO-AT dry hand and leave for 8-12 hours. Apply 2 coats of PRIMER SOLVER 24 hours of each other, then two coats of antifouling COASTAL T.F. at a distance of at least 8 hours apart. 

Hulls already painted. If the old antifouling is in good condition and well anchored simply apply one or two coats of PRIMER SOLVER, first with 2 coats of varnish over COASTAL T.F. at a distance of at least 8 hours between coats. 

Fiberglass and plastic. Decrease with detergent and water and rinse. Sand lightly with fine sandpaper and remove dust. Apply a POLY FIBER PRIMER and after 24 hours sand with fine sandpaper. then apply two coats of COASTAL T.F. at a distance of at least 8 hours apart.