Svernigraf Paint Remover - 0.75 LT - 7KC0000-075:
Newly formulatied, solvent based paint remover of low environmental impact.
The product does not contain Dichloromethane or N-Methyl Pyrrolidone and meets new regulations.
Although it might require longer application times, the product can be used for the same purposes as the old traditional formulation containing Dichloromethane.
Removes wall paints as well as one or two-component varnishes, primers and enamels from metals and wooden substrates.
Color: Transparent (Gel)
SURFACE PREPARATION AND APPLICATION PROCEDURE
Wall paints. Enamels and varnishes applied onto metals and wooden substrates.
Apply evenly and abundantly on the paint to be removed using a spatula or a soft brush.
Wait until the paint has softened completely and remove it with a metal spatula.
Remove all the lifted paint with rags, paper or a wet sponge.
Application time normally varies from 10 to 60 minutes.
In the case of thick paint layers or two component paints, it may be necessary to wait a longer time period (1-3 hours) before the paint to be removed is properly softened if necessary repeat the application.
The indicative coverage is approx. 2-3 m2/Lt but this will largely depend on the thickness and the type of paint to be removed.
SAFETY PRECAUTIONS:
Before starting paint application please carefully read all the safety precautions indicated on the label of each can or in the product safety data sheet available on request.
For further information please do not hesitate to contact our technical staff.
NOTES:
The above information is given to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, no warranty is given or to be implied in respect of such information.
Our technical staff can be contacted to study customer's specific requirements involving our products in order to enable their most effective use.
Dilution rates and drying times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F) and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.