Hydraulic Trim Tab Hardware Pack - H1170A:
Bennett actuators are built to last and have a lifetime limited warranty.
The piston-like arms push tabs into position. All models provide a 2.5″ stroke.
In the unlikely event that you need to replace an actuator, it will not come with any mounting hardware. Bennett recommends that when you replace an actuator, you replace the hardware used to to install it by purchasing this H1170A Hardware Kit.
Trim Tab Hydraulic Hardware Kit H1170A includes:
• Two 3" brass pipe nipples
• Two brass female elbows
• Two tube bending clips
• Six #14 x 1-1/2" full threaded screws
• Four 1/4-20 x 3/4" machine screws
• Eight nylon hangers (P-clips; not shown)
• One mounting bracket with four #10 x 1" full-threaded screws
• Two nuts with ferrules.