Costiera T.F. - 2.50 LT - B65570-025X:
Hard antifouling secure reliability with high percentage of cuprous oxide and ideal special substances for use in any type of sea.
It provides reliable protection on the hull, after application of a suitable primer.
It is applied to wooden hulls, iron and fiberglass (not suitable for aluminum hulls).
Ideal to speed even over 30 nodes.
Available colors: Black and Dark Blue.
USAGE:
PREPARING THE SURFACE AND APPLICATION CYCLE:
Hulls in new iron. Of iron sandblasted to grade 2.5 applies a coat of two-component EPOZINC 2C, letting it dry for 12-24 hours. (If it is not possible sandblasting is recommended to mechanically bring the iron again, clean the surface and apply one coat of CROMOMINIO-AT, leaving to dry for 8-12 hours.) Then apply two coats of PRIMER SOLVER 24 hours between of them. Overpainted with 2 coats of antifouling COASTAL T.F. at a distance at least 8 hours apart.
Hulls in new wood. Apply a CROMOMINIO-AT dry hand and leave for 8-12 hours. Apply 2 coats of PRIMER SOLVER 24 hours of each other, then two coats of antifouling COASTAL T.F. at a distance of at least 8 hours apart.
Hulls already painted. If the old antifouling is in good condition and well anchored simply apply one or two coats of PRIMER SOLVER, first with 2 coats of varnish over COASTAL T.F. at a distance of at least 8 hours between coats.
Fiberglass and plastic. Decrease with detergent and water and rinse. Sand lightly with fine sandpaper and remove dust. Apply a POLY FIBER PRIMER and after 24 hours sand with fine sandpaper. then apply two coats of COASTAL T.F. at a distance of at least 8 hours apart.
SAFETY PRECAUTIONS:
Before starting paint application attention should be paid to the symbols of risk specified on the label of each can.
Please carefully read all the safety precautions advised on the label.
NOTES:
This information is provided to the best of our current knowledge, however, because the conditions of use of our products are beyond our control, this information does not constitute any kind of implied warranties; in that sense the supplying company accepts from now responsibility that can be connected to an abnormal use of the products.
The Engineering Department at your location is available for any questions related to the use of our products.
The percentages of dilution and the drying time are to be considered only indicative, in relation to a temperature of 20 ° C and are therefore subject to change with the change of temperature, in the presence of particular weather conditions or application determining factors at the time of 'application.